Product Features   The P-Splint synthetic splint is made from a Glass Fiber. Hardness strengthen 20times more than general plaster of paris bandage. Weight is 5times lighter than general plaster of paris bandage.

• Finished P-Splint will support combustion under normal circumstances. Uncured polyurethane tapes will burn over an open flame.
• Thanks to the specially-made Clip, our products have complete air-insulation and you can be favored with the extra long storage.
• You can use our products without folding, because the edge of our products does not touch the skin.
• We have full size and you will have no loss.

Method of Use for Pre-Cut type

1. First, cut off the right length of P-Splint according to the area and the status of the wound.
2. Fold the P-Splint about 2~3 cm and push in into the packing box to preserve the remaining product.
3. Flatten the end of aluminum foil and reseal remaining roll with special clip. Fold the foil in double layer for double sealing effect.
4. Dip the cut out P-Splint into water and squeeze 3~4 times or spray water on only one side for convenience.
5. If necessary, drain the wet P-Splint against a towel to remove additional water.
6. Apply the P-Splint to the wounded area and secure with elastic bandage. If necessary, adjust the P-Splint is secured to patient's comfortable position.

Product Storage

Care should be taken to avoid puncturing pouch as this will cause the splint to harden prematurely in the package. It is recommended that this product be stored at room temperature(20~25¡É / 70~75¢µ). Higher or lower temperature may affect the self life. Each pouch, esp. edge sides of the roll, should be gently squeezed prior to opening to check suitability for application. The roll should be soft and pliant. Do not use tape that feels hard. Each box and pouch is marked with the date of manufacture. For optimum performance, ROTATE STOCK.

Package

	10"	12"	15"	30"	35"	45"	5yds
2"
3"
4"
5"
6"

¡¡